£21.95 exc. & £26.34 inc.
25mm length (1 kg per bag)
When using nails to fix lead into place only copper or stainless steel nails should be used. These ensure security, longevity and compliancy with relevant guidelines.
These high-quality copper nails are specifically designed and manufactured to meet the requirements of British Standard BS-1202-1&2. This stipulates that nails should have shanks that are annular ring, helical ring or serrated and be no less than 20 mm in length.
25mm length copper nails (1 kg per bag)
When using copper nails to fix lead into place only copper or stainless steel nails should be used. These ensure security, longevity and compliancy with relevant guidelines.
These high-quality copper nails are specifically designed and manufactured to meet the requirements of British Standard BS-1202-1&2. This stipulates that nails should have shanks that are annular ring, helical ring or serrated and be no less than 20 mm in length.
LEADWORX TOOLS
Calculate from measurements, or estimate the angle from a photograph.
Measure the vertical rise and horizontal run between the same two points.
Use the same unit for both, such as mm or cm. Run is not the sloping roof length or automatically the full building width.
Enter your measurements to begin.
Enter measurements first.
These formats describe the same slope; they are not product size recommendations.
Use a square-on view of the roof profile, with a known horizontal reference in the same plane.
The photo box opens your camera on supported phones and tablets. On a computer, choose a photo file or drop one into the box.
Processed on your device by this tool. JPG, PNG or WebP, up to 20 MB and 24 megapixels. Export HEIC as JPG first.
Tap the photo box or choose a saved photo.
Tap four points: two on the roof slope, then two on a level reference. Drag points to adjust. Use long lines for a better estimate.
Focus the photo. Arrow keys move the marker; Shift moves 10 pixels. Enter adds a point. Select a placed point below to adjust it with the arrows. Escape returns to the free marker.
No points placed.
Mark the photo first.
The reference line corrects camera tilt, not perspective or lens distortion. A photo cannot guarantee the angle needed for manufacture.
Switch to Ireland 
Rich –
Worked very well
David Ramsay –
Well made and look the part. However I found the diameter (3.25?) and the aggressive rings made it very difficult to drive the nails in. I was trying to fix to tan inside 18mm sark boards between 425 centres. There was give/bounce in the boards so the nails started in but around 50% were very difficult to hammer in. I reverted to 32×2.65 and they drove in fine but penetrated the timber by a few mm. Maybe just not good for my roof and if the wood was more “solid” then these would have worked nicely without penetrating the wood.
Price and delivery was good.